Wishing Well

Materials Needed:

• Tin Can
• Popsicle Sticks
• Glue

Instructions:
Glue popsicle sticks around the outside of the tin tan until it is completely covered (figure 1). Once you are done, wrap a few rubber bands around the can to hold the sticks in place until the glue dries. Glue 2 more popsicle sticks on the can as shown in figure 2. They should be directly across from each other. Wrap rubber bands around these also.

While the can is drying, you can start constructing the roof of your wishing well. Lay 2 posicle sticks down as shown in figure 3. Put a dab of glue on each end of another popsicle stick and lay it across the other 2 as shown in figure 4. Repeat this until yours looks similar to figure 5. Repeat these steps so you end up with 2 pieces that look like figure 5. Also, glue together a set of 45 degree angles out of popsicles sticks (figure 6). Set all these pieces aside to dry.

Once everything is dry, you can start gluing the pieces together! Glue the two 45 degree angles on the can as shown in figure 7. Place a clothes pin on them and set aside until it completely dry. Once these are dry, glue on the roof pieces you made from above (figure 8). Top it off with one popsicle stick glued across the top of your wishing well's roof. Once again, postion clothes pins on the pieces until dry.

Once all the glue is dry, your wishing well is ready for pennies or whatever else you want to do with it!