Instructions:
Cut a piece of construction paper into a square that will fit into the cd case. Place your card in the center of the square and trace around it. Cut out the rectangle you traced, cutting it about 1/4 inch smaller than the line you traced (figure 1). Put a dab of glue in each corner of your square, on the opposite side of your trace lines. Open the cd case and stick your square on the inside of the clear cd case cover.
Cut a strip of construction paper about 1 inch wide and 6 inches long. Cut another piece of construction paper about 1 inch wide and 4 inches long. Lay your card down between the trace lines in the center of your square. Lay the strips over the back of the card (figure 2). Tape the edges of your strips so they hold your card in place. Make sure the tape does not get on the card (figure 3).
Close the cd case. Glue a pop can tab on the back of the cd case towards the top and you can hang up your Frame on your wall, or add a magent strip to the baack and hang it on your fridge! You can even add stickers and other miscellaneous things to decorate your frame.
- See a larger photo of this craft completed by Éric.
|
| 